Search
Now showing items 1-10 of 35
Correlation between densification rate and microstructure evolution of mechanically activated BaTiO3
(Taylor & Francis Ltd, Abingdon, 2005)
Increasing demands on the quality of electronic ceramics requires a well-controlled correlation between particle morphology and processing conditions. Since mechanical activation is one of the methods for modification of ...
SEM investigation of domain structure in (Ba,Ca,Pb)TiO3
(Elsevier Sci Ltd, Oxford, 1999)
In the present paper the microstructure and domain structure in modified BaTiO3 with Pb and Ca as additives have been investigated using SEM technique. The (Ba,Pb)TiO3 and (Ba,Ca,Pb)TiO3 ceramics show a slight difference ...
DPR analysis of microstructural evolution of ZnO ceramics
(Trans Tech Publications Ltd, Durnten-Zurich, 2004)
It is well known that, due to their specific properties, ZnO - based materials are frequently used in electrotechnics and electronics. Since these properties are very Much dependent on the microstructural state of material ...
Application of the master sintering curve theory to non-isothermal sintering of BaTiO3 ceramics
(6th Conference of the Yugoslav Materials Research Society, YUCOMAT VI: Current Research in Advanced Materials and Processes, 2005)
In this paper a practical approach to the analysis of sintering of BaTiO3 using the Master Sintering Curve concept has been presented. Non-isothermal sintering of high-purity non-doped BaTiO3 ceramics was monitored using ...
Photoacoustic spectroscopy investigation of sintered zinc-tin-oxide ceramics
(Savez hemijskih inženjera, Beograd, 2007)
In this paper the changes that occured in differently activated ZnO-SnO(2) and sintered samples were investigated using photoacoustic spectroscopy. ZnO and SnO(2) powders, mixed in the molar ratio 2:1, were mechanically ...
New Frontiers: Miniaturization and Higher Level BaTiO3 -Ceramics Microelectronics Circuits Integration
(Belgrade : Serbian Ceramic Society, 2012)
Since that the scientific and technological efforts to further miniaturization, "better packaging" and higher levels of integration of electronic components and subsystems, and modern microelectronics devices are increasingly ...
Structural and Electrical Properties of Sintered Zinc-titanate Ceramics
(2005)
Poster presented at the ELECTROCERAMICS X, June 18-22, 2006, Toledo, Spain
Properties of Magnesium Titanate Ceramic Obtained by Two Stage Sintering
(2014)
Poster presented at the III Serbian Ceramic Society Conference, 29th September - 1st October, Belgrade, 2014
Structural characterization and electrical properties of sintered magnesium-titanate ceramics
(Belgrade : Materials Research Society of Serbia, 2012)
In this article the influence of ball milling process on structure of MgO-TiO2 system, along with its influence on electrical properties of post-sintering samples, were investigated. Mixtures of MgO-TiO2 powders were ...
Structural analyses of sintered MT and BZT ceramics
(Belgrade : Serbian Society for Microscopy, 2010)
Development of dielectric materials is increasing with a rapid progress in mobile and satellite communications systems, where magnesium titanates find their place owing to good dielectric properties. Recently it has been ...