Претраживање
Приказ резултата 1-10 од 10
Evaluation of adsorption performance and quantum chemical modeling of pesticides removal using cell-mg hybrid adsorbent
(International Institute for the Science of Sintering (IISS), 2021)
Magnetite (MG) modified cellulose membrane (Cell-MG), obtained by reaction of 3-aminosilane and subsequently with diethylenetriaminepentaacetic acid dianhydride functionalized waste Cell fibers (Cell-NH2 and Cell-DTPA, ...
Novel Magnetic Polymer/bentonite Composite: Characterization and Application for Re(VII) and W(VI) Adsorption
(International Institute for the Science of Sintering (IISS), 2022)
A novel magnetic polymer/bentonite composite was prepared by suspension copolymerization of glycidyl methacrylate and ethylene glycol dimethacrylate in the presence of magnetic bentonite (MB-PGME) and functionalized with ...
Removal of the As(V) and Cr(VI) from the Water Using Magnetite/3D-Printed Wollastonite Hybrid Adsorbent
(International Institute for the Science of Sintering (IISS), 2022)
In this study, the structure, morphology and composition of the synthesized magnetite/3D-printed wollastonite (3D_W/M) composite were characterized, and its adsorption performance with respect to As(V) and Cr(VI) were ...
Structure and Properties of Nanocrystalline Tetragonal BaTiO3 Prepared by Combustion Solid State Synthesis
(Međunarodni Institut za nauku o sinterovanju, Beograd, 2020)
Barium titanate (BaTiO3) attracts high scientific and technological attention due to good dielectric and electromechanical properties. Although BaTiO3 is one of the most frequently investigated ferroelectric materials, the ...
Preparation and Characterization of Novel Glycidyl Methacrylate/Clay Nanocomposites
(Science of SinteringScience of Sintering, 2022)
The impact of the type and amounts of nanofiller on the features of the glycidyl methacrylate-co-ethylene glycol dimethacrylate (GMA-co-EGDMA)/organomodified montmorillonite (OMt) nanocomposites that were prepared by in ...
TiO2 Nanotubes Film/FTO Glass Interface: Thermal Treatment Effects
(Science of SinteringScience of Sintering, 2022)
Pure Ti films deposited by radio-frequency magnetron sputtering on FTO glass were anodized to fabricate TiO2 nanotubes (NTs) arrays. The TiO2 NTs/FTO samples were sintered at 450, 550 and 630o C, in ambient air. The thermal ...
Understanding the effect of synthesis and sintering temperature on the functional properties of barium titanate/cobalt ferrite composites
(Science of SinteringScience of Sintering, 2023)
To investigate the effect of synthesis procedure and sintering temperature on the functional properties of perovskite/spinel ceramics, BaTiO3/CoFe2O4 composites were prepared by thermal decomposition, coprecipitation, and ...
Dielectric Properties of Mechanically Activated Strontium Titanate Ceramics
(Science of SinteringScience of Sintering, 2022)
In this study, microstructure evolution and dielectric properties of SrTiO3 ceramic have been investigated, whereby mechanical activation of SrTiO3 powders was used to modify the functional properties of ceramic materials. ...
Multiferroic heterostructure BaTiO3/ε-Fe2O3composite obtained by in situ reaction
(International Institute for the Science of Sintering (IISS), 2021)
Solid-state reaction between BaTiO3and Fe2O3was used to produce a multiferroic heterostructure composite. Commercial BaTiO3and Fe(NO3)3•9H2O were suspended in ethanol for 30 minutes in an ultrasound bath. The prepared ...
Oxide powder mixture with poly-vinyl alcohol (PVA) and added polyethylene glycol (PEG) as plasticizer
(Science of SinteringScience of Sintering, 2023)
Powder mixture consisted of ZnO, Mn2O3 (MnCO3) and Fe2O3 blended powders, was found laminating during compaction. Polyvinyl alcohol (PVA) and a combination of PVA with polyethylene glycol (PEG) added as a plasticizer, were ...