Претраживање
Приказ резултата 1-10 од 28
Understanding the effect of synthesis and sintering temperature on the functional properties of barium titanate/cobalt ferrite composites
(Science of SinteringScience of Sintering, 2023)
To investigate the effect of synthesis procedure and sintering temperature on the functional properties of perovskite/spinel ceramics, BaTiO3/CoFe2O4 composites were prepared by thermal decomposition, coprecipitation, and ...
Oxide powder mixture with poly-vinyl alcohol (PVA) and added polyethylene glycol (PEG) as plasticizer
(Science of SinteringScience of Sintering, 2023)
Powder mixture consisted of ZnO, Mn2O3 (MnCO3) and Fe2O3 blended powders, was found laminating during compaction. Polyvinyl alcohol (PVA) and a combination of PVA with polyethylene glycol (PEG) added as a plasticizer, were ...
Multiferroic heterostructure BaTiO3/ε-Fe2O3composite obtained by in situ reaction
(International Institute for the Science of Sintering (IISS), 2021)
Solid-state reaction between BaTiO3and Fe2O3was used to produce a multiferroic heterostructure composite. Commercial BaTiO3and Fe(NO3)3•9H2O were suspended in ethanol for 30 minutes in an ultrasound bath. The prepared ...
Dielectric Properties of Mechanically Activated Strontium Titanate Ceramics
(Science of SinteringScience of Sintering, 2022)
In this study, microstructure evolution and dielectric properties of SrTiO3 ceramic have been investigated, whereby mechanical activation of SrTiO3 powders was used to modify the functional properties of ceramic materials. ...
Advantages of Combined Sintering Compared to Conventional Sintering of Mechanically Activated Magnesium Titanate
(Međunarodni Institut za nauku o sinterovanju, Beograd, 2014)
In this article, the advantages of combined sintering in comparison with the conventional one, of mechanically activated magnesium titanate ceramic were investigated. The stoichiometric mixtures of MgO and TiO2 were ...
Influence of mechanical activation on structural and electrical properties of sintered MgTiO3 ceramics
(Međunarodni Institut za nauku o sinterovanju, Beograd, 2009)
The aim of this work was to analyze the influence of mechanical activation on the MgCO3-TiO2 system. Mixtures of MgCO3-TiO2 were mechanically activated for 15, 30, 60 and 120 minutes in a planetary ball mill and after that ...
Application of the intergranular impedance model in correlating microstructure and electrical properties of doped BaTiO3
(Međunarodni Institut za nauku o sinterovanju, Beograd, 2009)
Microstructure properties of barium-titanate based materials, expressed in grain boundary contacts, are of basic importance for electric properties of this material. In this study, the model of intergranular impedance ...
Enthalpy-entropy Compensation for n-hexane Adsorption on Y Zeolite Containing Transition Metal Cations
(Međunarodni Institut za nauku o sinterovanju, Beograd, 2015)
In this work, the values of entropy changes related to n-hexane adsorption onto cation exchanged Y zeolite were calculated from differential heats. Various transition metal cations (Co2+, Ni2+, Zn2+ and Cd2+) were introduced ...
Structural and Electrical Properties of Ti Doped alpha-Fe2O3
(Međunarodni Institut za nauku o sinterovanju, Beograd, 2013)
In this work we have analyzed the effects of Ti doping on structural and electrical properties of alpha-Fe2O3. When the amount of added Ti (5 wt.% TiO2) was within the solubility degree and XRD, SEM and EDS analysis revealed ...
Investigation of Sintering Kinetics of Magnesium Titanate
(Međunarodni Institut za nauku o sinterovanju, Beograd, 2013)
Obtaining new materials including sintered electronic materials using different procedures is the consequence of long complex and expensive experimental work. However, the dynamics of expansive development of electronic ...