Претраживање
Приказ резултата 21-28 од 28
Influence of Prolonged Sintering Time on Density and Electrical Properties of Isothermally Sintered Cordierite-based Ceramics
(Međunarodni Institut za nauku o sinterovanju, Beograd, 2013)
Mechanical activation is a commonly used and relatively fast and inexpensive procedure for sample preparation before the sintering process. Cordierite, a stoichiometric mixture of three different oxides (2MgO center dot ...
Structural and Electrical Properties of Ti Doped alpha-Fe2O3
(Međunarodni Institut za nauku o sinterovanju, Beograd, 2013)
In this work we have analyzed the effects of Ti doping on structural and electrical properties of alpha-Fe2O3. When the amount of added Ti (5 wt.% TiO2) was within the solubility degree and XRD, SEM and EDS analysis revealed ...
Investigation of Sintering Kinetics of Magnesium Titanate
(Međunarodni Institut za nauku o sinterovanju, Beograd, 2013)
Obtaining new materials including sintered electronic materials using different procedures is the consequence of long complex and expensive experimental work. However, the dynamics of expansive development of electronic ...
Advantages of Combined Sintering Compared to Conventional Sintering of Mechanically Activated Magnesium Titanate
(Međunarodni Institut za nauku o sinterovanju, Beograd, 2014)
In this article, the advantages of combined sintering in comparison with the conventional one, of mechanically activated magnesium titanate ceramic were investigated. The stoichiometric mixtures of MgO and TiO2 were ...
Synthesis of BaTiO3 from a mechanically activated BaCO3-TiO2 system
(Međunarodni Institut za nauku o sinterovanju, Beograd, 2008)
In this article the solid state reaction of BaTiO3 formation from a mechanically activated BaCO3-TiO2 system has been investigated. An equimolar mixture of BaCO3 and TiO2 powders was activated in a planetary ball mill in ...
Influence of mechanical activation on microstructure and crystal structure of sintered MgO-TiO2 system
(Međunarodni Institut za nauku o sinterovanju, Beograd, 2010)
Mixtures of MgO-TiO2 were mechanically activated using high-energy planetary ball mill during 5, 10, 20, 40, 80 and 120 minutes. Sintering process was preformed in air at 1100°-1400°C for 2h. The decrease in powder's ...
Evaluation of adsorption performance and quantum chemical modeling of pesticides removal using cell-mg hybrid adsorbent
(International Institute for the Science of Sintering (IISS), 2021)
Magnetite (MG) modified cellulose membrane (Cell-MG), obtained by reaction of 3-aminosilane and subsequently with diethylenetriaminepentaacetic acid dianhydride functionalized waste Cell fibers (Cell-NH2 and Cell-DTPA, ...
Novel Magnetic Polymer/bentonite Composite: Characterization and Application for Re(VII) and W(VI) Adsorption
(International Institute for the Science of Sintering (IISS), 2022)
A novel magnetic polymer/bentonite composite was prepared by suspension copolymerization of glycidyl methacrylate and ethylene glycol dimethacrylate in the presence of magnetic bentonite (MB-PGME) and functionalized with ...