Polymer characteristics and mechanical properties of bulk-fill, giomer, fiber-reinforced and low-shrinkage composites

Abstract

Introduction/Objective. The objective was to determine the degree of conversion (DC), cross-link density, percentage of leachable monomers, flexural strength (FS), and hardness (HV) of nanohybrid, nanofilled bulk-fill, giomer, fiber-reinforced, and low-shrinkage composites. Methods. Standardized specimens (n = 5/group) of Tetric EvoCeram Bulk Fill, Filtek Bulk Fill, Beautifil, EverX posterior, Kalore, Filtek Z250 (microhybrid control), and Tetric EvoCeram (nanohybrid control) were subjected to micro-Raman spectroscopy, three-point bending, and HV. Cross-linking density and leachable monomers were ascertained based on the ratio of HV and DC before and after immersion in absolute ethanol. Results. DC was in the range 50.4–70.5%, the highest for Filtek Bulk and the lowest for Kalore. The highest %DC change was in Beautifil (10.3%) and the lowest in Filtek Bulk (1.4%) and Z250 (1.28%). FS ranged between 78.9 MPa (TEC) and 126.7 MPa (Filtek Bulk). HV ranged between 58.6 (Kalore) and 113.9 (Z250) and significantly decreased post-immersion (19–55%). HV48h inversely correlated to HV% loss (r = -0.761), whilst DC positively correlated with FS (r = 0.893). Conclusion. Filtek Bulk, EverX, and Z250 showed the highest DC. The lowest DC and mechanical properties were observed for Kalore. The greatest cross-link density was shown by Filtek Bulk. There were up to 10% of leachable monomers. DC and FS positively correlated.