Претраживање
Приказ резултата 11-20 од 35
DPR analysis of microstructural evolution of ZnO ceramics
(Trans Tech Publications Ltd, Durnten-Zurich, 2004)
It is well known that, due to their specific properties, ZnO - based materials are frequently used in electrotechnics and electronics. Since these properties are very Much dependent on the microstructural state of material ...
New Frontiers: Miniaturization and Higher Level BaTiO3 -Ceramics Microelectronics Circuits Integration
(Belgrade : Serbian Ceramic Society, 2012)
Since that the scientific and technological efforts to further miniaturization, "better packaging" and higher levels of integration of electronic components and subsystems, and modern microelectronics devices are increasingly ...
Structural and Electrical Properties of Sintered Zinc-titanate Ceramics
(2005)
Poster presented at the ELECTROCERAMICS X, June 18-22, 2006, Toledo, Spain
Structural analyses of sintered MT and BZT ceramics
(Belgrade : Serbian Society for Microscopy, 2010)
Development of dielectric materials is increasing with a rapid progress in mobile and satellite communications systems, where magnesium titanates find their place owing to good dielectric properties. Recently it has been ...
Properties of Magnesium Titanate Ceramic Obtained by Two Stage Sintering
(2014)
Poster presented at the III Serbian Ceramic Society Conference, 29th September - 1st October, Belgrade, 2014
Reaction kinetics of mechanically activated cordierite based ceramics studied via DTA
(Ljubljana : Central and Eastern European Committee for Thermal Analysis and Calorimetry, 2015)
Cordierite, 2MgO•2Ah03•5Si02 (MAS), is a very attractive high-temperature ceramic material. In order to accelerate the process of sintering, 5.00 mass% Mo03 was added to the starting mixtures. The mechanical activation of ...
Sintering of alumina doped with different oxides, followed by sensitive dilatometer
(Belgrade : Materials Research Society of Serbia, 2018)
Sintered alumina powder represents suitable material for usage in various industry fields (e.g., as chip carriers in electronics, microwaves, jewelry production), due to convenient physical properties, such as sinterability, ...
Influence of MoO3 on cordierite ceramics sintering and crystallization
(Belgrade : Materials Research Society of Serbia, 2013)
The influence of MoO3 on the process of cordierite ceramics preparation, 2MgO-2Al2O3-5SiO2 (MAS) was researched by sintering followed binary systems: MgO/MoO3 (sintered at 850 ºC and 1000 ºC), Al2O3/Bi2O3 and SiO2/Bi2O3 ...
Influence of one activated component on the sintering process of three phase system
(Belgrade : Materials Research Society of Serbia, 2013)
According to its low temperature thermal expansion coefficient, low dielectric constant, also good mechanical properties, cordierite, 2MgO×2Al2O3×5SiO2, represents a very attractive hightemperature ceramic material. In ...
Characterization of pressure-less sintered MgO-Al2O3-SiO2-TeO2 system
(Belgrade : Materials Research Society of Serbia, 2017)
In this study, sintering of two systems was investigated in parallel, pure cordierite 2MgO:2Al2O3:5SiO2, and cordierite with addition of 5 mass % TeO2. Green bodies were prepared from powder mixtures mechanically activated ...