Претраживање
Приказ резултата 11-20 од 22
Effect of Mechanical Activation on the Densification Behavior of MgAl2O4 Spinel
(The Ceramic Society of Japan, 2019)
Magnesium aluminate and other alumina-based spinels attract attention due to their high hardness, high mechanical strength, and low dielectric constant. MgAl2O4 was produced by solid-state reaction between MgO and a-Al2O3 ...
Reaction kinetics of mechanically activated cordierite based ceramics studied via DTA
(Ljubljana : Central and Eastern European Committee for Thermal Analysis and Calorimetry, 2015)
Cordierite, 2MgO•2Ah03•5Si02 (MAS), is a very attractive high-temperature ceramic material. In order to accelerate the process of sintering, 5.00 mass% Mo03 was added to the starting mixtures. The mechanical activation of ...
Influence of one activated component on the sintering process of three phase system
(Belgrade : Materials Research Society of Serbia, 2013)
According to its low temperature thermal expansion coefficient, low dielectric constant, also good mechanical properties, cordierite, 2MgO×2Al2O3×5SiO2, represents a very attractive hightemperature ceramic material. In ...
Dilatometric Analysis of Mechanically Activated SrTiO3 Powder
(Belgrade : Serbian Ceramic Society, 2013)
Strontium-titanate powder was mechanically activated in a planetary ball mill for 0, 5, 10, 30, 60, 90 and 120 minutes. Non-isothermal sintering of non-activated and activated SrTiO3 powder samples in the temperature ...
The influence of mechanical activation on the electrical properties of Ba0.77Sr0.23TiO3
(2013)
Poster presented at the conference Advanced Ceramics and Application II – Serbian Ceramic Society, Belgrade, September 30 – October 1, 2013
The effect of Hot Isostatic Pressing on the MT sample densities
(Belgrade : Serbian Ceramic Society, 2015)
Mechanically activated powders (0, 10, 40, 80 and 160 minutes) were formed by isostatic pressure 300 MPa to cylindrical green bodies (φ 12 mm). First set of samples was sintered at 1300°C for 30 min in air (heating rate ...
Influence of mechanical activation on BaO-ZnO-TiO2 system
(Belgrade : Institute of Technical Sciences of SASA, 2008)
The influence of mechanical activation on BaO-ZnO-TiO2 sistem was observed. Mixtures of BaO-ZnO-TiO2 were mechanically activated using high-energy planetary ball mill during 0,5, 10, 20, 40 and 80 minutes. XRD analyses ...
Density and electrical properties of cordierite based ceramics as function of compaction pressure
(Belgrade : Serbian Ceramic Society, 2013)
Mechanical activation is widely used and relatively inexpensive procedure for sintering process sample preparation. However, the influence of pressure, which is used for compaction, has not been completely investigated. ...
The Morphological Characterization of Mechanically Activated ZnO Powder
(Belgrade : Serbian Ceramic Society, 2014)
The authors investigated the morphological characteristics of mechanically activated ZnO powder. ZnO powder was mechanically activated for 2, 5, 10 and 30 minutes in a planetary ball mill. Mechanical activation introduces ...
The influence of mechanical activation on the electrical properties of Ba0.77Sr0.23TiO3 ceramics
(Belgrade : Serbian Ceramic Society, 2013)
Ferroelectric ceramic barium strontium titanate (Ba0.77Sr0.23TiO3), BST, was prepared by solid-state reactions using starting powders of barium carbonate (BaCO3), strontium carbonate (SrCO3) and titanium dioxide (TiO2-anatase). ...