Претраживање
Приказ резултата 11-20 од 35
Correlation between densification rate and microstructure evolution of mechanically activated BaTiO3
(Taylor & Francis Ltd, Abingdon, 2005)
Increasing demands on the quality of electronic ceramics requires a well-controlled correlation between particle morphology and processing conditions. Since mechanical activation is one of the methods for modification of ...
Structural and Electrical Properties of Sintered Zinc-titanate Ceramics
(2005)
Poster presented at the ELECTROCERAMICS X, June 18-22, 2006, Toledo, Spain
Influence of one activated component on the sintering process of three phase system
(Belgrade : Materials Research Society of Serbia, 2013)
According to its low temperature thermal expansion coefficient, low dielectric constant, also good mechanical properties, cordierite, 2MgO×2Al2O3×5SiO2, represents a very attractive hightemperature ceramic material. In ...
New Frontiers: Miniaturization and Higher Level BaTiO3 -Ceramics Microelectronics Circuits Integration
(Belgrade : Serbian Ceramic Society, 2012)
Since that the scientific and technological efforts to further miniaturization, "better packaging" and higher levels of integration of electronic components and subsystems, and modern microelectronics devices are increasingly ...
Structural analyses of sintered MT and BZT ceramics
(Belgrade : Serbian Society for Microscopy, 2010)
Development of dielectric materials is increasing with a rapid progress in mobile and satellite communications systems, where magnesium titanates find their place owing to good dielectric properties. Recently it has been ...
Properties of Magnesium Titanate Ceramic Obtained by Two Stage Sintering
(2014)
Poster presented at the III Serbian Ceramic Society Conference, 29th September - 1st October, Belgrade, 2014
Influence of MoO3 on cordierite ceramics sintering and crystallization
(Belgrade : Materials Research Society of Serbia, 2013)
The influence of MoO3 on the process of cordierite ceramics preparation, 2MgO-2Al2O3-5SiO2 (MAS) was researched by sintering followed binary systems: MgO/MoO3 (sintered at 850 ºC and 1000 ºC), Al2O3/Bi2O3 and SiO2/Bi2O3 ...
Characterization of pressure-less sintered MgO-Al2O3-SiO2-TeO2 system
(Belgrade : Materials Research Society of Serbia, 2017)
In this study, sintering of two systems was investigated in parallel, pure cordierite 2MgO:2Al2O3:5SiO2, and cordierite with addition of 5 mass % TeO2. Green bodies were prepared from powder mixtures mechanically activated ...
Dielectric properties of barium-titanate sintered from tribophysically activated powders
(Elsevier Sci Ltd, Oxford, 1999)
It has been well known that the tribophysical (mechanical) activation could be used as a method for modification of physicochemical properties of dispersed systems such as polycrystalline mixture of oxides. In this study, ...
Microstructure evolution and sintering kinetics of ZnO
(Belgrade : Institute of Technical Sciences of SASA, 2010)
The aim of this paper was to analyse the sintering kinetics and microstructure evolution of ZnO. Powder was isothermally sintered (15, 30, 60, 90 and 120 minutes) in the temperature range from 800 to 1200oC. The values of ...