Pretraživanje
Prikaz rezultata 11-20 od 35
Structural characterization and electrical properties of sintered magnesium-titanate ceramics
(Belgrade : Materials Research Society of Serbia, 2012)
In this article the influence of ball milling process on structure of MgO-TiO2 system, along with its influence on electrical properties of post-sintering samples, were investigated. Mixtures of MgO-TiO2 powders were ...
Characterization of pressure-less sintered MgO-Al2O3-SiO2-TeO2 system
(Belgrade : Materials Research Society of Serbia, 2017)
In this study, sintering of two systems was investigated in parallel, pure cordierite 2MgO:2Al2O3:5SiO2, and cordierite with addition of 5 mass % TeO2. Green bodies were prepared from powder mixtures mechanically activated ...
Structural analyses of sintered MT and BZT ceramics
(Belgrade : Serbian Society for Microscopy, 2010)
Development of dielectric materials is increasing with a rapid progress in mobile and satellite communications systems, where magnesium titanates find their place owing to good dielectric properties. Recently it has been ...
New Frontiers: Miniaturization and Higher Level BaTiO3 -Ceramics Microelectronics Circuits Integration
(Belgrade : Serbian Ceramic Society, 2012)
Since that the scientific and technological efforts to further miniaturization, "better packaging" and higher levels of integration of electronic components and subsystems, and modern microelectronics devices are increasingly ...
Influence of MoO3 on cordierite ceramics sintering and crystallization
(Belgrade : Materials Research Society of Serbia, 2013)
The influence of MoO3 on the process of cordierite ceramics preparation, 2MgO-2Al2O3-5SiO2 (MAS) was researched by sintering followed binary systems: MgO/MoO3 (sintered at 850 ºC and 1000 ºC), Al2O3/Bi2O3 and SiO2/Bi2O3 ...
Structural and Electrical Properties of Sintered Zinc-titanate Ceramics
(2005)
Poster presented at the ELECTROCERAMICS X, June 18-22, 2006, Toledo, Spain
Properties of Magnesium Titanate Ceramic Obtained by Two Stage Sintering
(2014)
Poster presented at the III Serbian Ceramic Society Conference, 29th September - 1st October, Belgrade, 2014
The influence of tribophysical activation on non-isothermal sintering of BaTiO3 ceramics
(Trans Tech Publications Ltd, Durnten-Zurich, 2006)
In this paper the influence of tribophysical activation on non-isothermal sintering of barium titanate has been investigated. BaTiO3 Powders were tribophysically activated in a planetary ball mill for 0, 60 and 120 min., ...
Adsorption capacity of wollastonite based adsorbents with porous structure controlled with different progeny agents
(Belgrade : Serbian Ceramic Society, 2016)
Porous wollastonite (WL) based adsorbents were fabricated by a pressureless sintering process by using low molecular weight poly(methyl methacrylate) (PMMA), nanocellulose (NC) and yeast as the pore forming agents. WL based ...
The influence of mechanical activation on the electrical properties of Ba0.77Sr0.23TiO3
(2013)
Poster presented at the conference Advanced Ceramics and Application II – Serbian Ceramic Society, Belgrade, September 30 – October 1, 2013